World Congress on Internet Security (WorldCIS-2011)
February 21-23, 2011, London, UK
Free Post-Conference London Tour (Travel Information)
The paper submission style files and templates are available for users of LaTeX and Microsoft Word:
PAPER SUBMISSION SYSTEM IS NOW CLOSED
IF YOU HAVE ANY QUERIES, PLEASE CONTACT email@example.com
Extended Abstract (Work in Progress)
The extended abstract should not exceed 2 pages (including introduction, body of knowledge and conclusion, supported by not more than 10 references). Please submit your extended abstract in PDF format at firstname.lastname@example.org
Please use the following guidelines when preparing your submission
Length: You are allowed a total of 6 pages for your paper (including all figures, tables, and references). Additional pages cost £25 per page with a maximum of 2 pages.
Main Title: The main title (on the first page) should begin 1-3/8 inches (3.49 cm) from the top edge of the page, centred, and in Times 14-point, boldface type. Capitalize the first letter of nouns, pronouns, verbs, adjectives, and adverbs; do not capitalize articles, coordinate conjunctions, or prepositions (unless the title begins with such a word). Leave two 12-point blank lines after the title.
Author Names and Affiliation: Author names and affiliations are to be centred beneath the title and printed in Times 12-point, non-boldface type. Multiple authors may be shown in a two- or three-column format, with their affiliations italicized and centred below their respective names. Include e-mail addresses if possible. Author information should be followed by two 12-point blank lines.
Margins: Any text or other material outside the margins specified below will not be accepted. All printed material, including text, illustrations, and charts, must be kept within a print area of 6-1/2 inches (16.51 cm) wide by 8-7/8 inches (22.51 cm) high. Do not write or print anything outside the print area. All text must be in a two-column format. Columns are to be 3-1/16 inches (7.85 cm) wide, with a 3/8 inch (0.81 cm) space between them. Text must be fully justified. A format sheet with the margins and placement guides is available as PDF file <format.pdf>. It contains lines and boxes showing the margins and print areas. If you hold it and your printed page up to the light, you can easily check your margins to see if your print area fits within the space allowed.
Second and Following Pages: The second and following pages should begin 1.0 inch (2.54 cm) from the top edge. On all pages, the bottom margin should be approximately 1-5/8 inches (4.13 cm) from the bottom edge of the page.
Typeface: We strongly encourage authors to use Times-Roman 10-point font. If a font face is used that is not recognized by the submission system, your proposal will not be reproduced correctly. No font size smaller than 9 points should be used anywhere in your paper, including figure captions. Avoid using bit-mapped fonts if possible. True-Type 1 fonts are preferred.
Main Text: Type your main text in 10-point Times, single-spaced. Do not use double-spacing. All paragraphs should be indented 1/4 inch (approximately 0.5 cm). Be sure your text is fully justified—that is, flush left and flush right. Please do not place any additional blank lines between paragraphs.
Do not put page numbers on your document. We will add appropriate page numbers to accepted papers.
Figure and Table: High quality, camera ready figures and/or tables are required. Captions should be 10-point boldface Helvetica (or a similar sans-serif font). Callouts should be 9-point non-boldface Helvetica. Initially capitalize only the first word of each figure caption and table title. Figures and tables must be numbered separately. For example: “Figure 1. Database contexts”, “Table 1. Input data”. Figure captions are to be centred below the figures. Table titles are to be centred above the tables.
First-Order Headings: For example, “1. Introduction”, should be Times 12-point boldface, initially capitalized, flush left, with one blank line before, and one blank line after. Use a period (“.”) after the heading number, not a colon.
Second-Order Headings: As in this heading, they should be Times 11-point boldface, initially capitalized, flush left, with one blank line before, and one after.
Third-Order Headings: Third-order headings, as in this paragraph, are discouraged. However, if you must use them, use 10-point Times, boldface, initially capitalized, flush left, preceded by one blank line, followed by a period and your text on the same line.
Footnotes: Use footnotes sparingly (or not at all) and place them at the bottom of the column on the page on which they are referenced. Use Times 8-point type, single-spaced. To help your readers, avoid using footnotes altogether and include necessary peripheral observations in the text (within parentheses, if you prefer, as in this sentence).
References: Number all bibliographical references in 9-point Times, single-spaced, at the end of your paper. When referenced in the text, enclose the citation number in square brackets, for example . Where appropriate, include the name(s) of editors of referenced books.
 V.F. Johnsmith, H.K. Honeyjones, and E.F. Berts, “Article Title”, Journal, Publisher, Location, Date, pp. 3-10.
 Jones, C.D., A.B. Smith, and E.F. Roberts, Book Title, Publisher, Location, Date.
Copyright © 2009 WorldCIS-2011