Centrifuge modelling of the pushover failure of an electricity transmission tower

Richards, D.J., White, D.J. and Lehane, B.M. (2010) Centrifuge modelling of the pushover failure of an electricity transmission tower. Canadian Geotechnical Journal, 47 (4), 413-424. (doi:10.1139/T09-112).

Abstract

Centrifuge model tests were conducted to examine foundation failure mechanisms during rapid horizontal pushover of an electricity transmission line support tower, simulating a broken transmission line response or wind gust loading. A model transmission tower supported on four pad foundations in clay and backfilled with sand was loaded horizontally and the loads at each foundation were measured during fast and slow pushover. The tests examined the influence of tensile resistance mobilized at the underside of the footings, which is difficult to reliably incorporate within design practice due to a lack of accepted quantitative design methods. The measured performance of the tower footings was compared with results from a series of tests where a single footing is subjected to purely vertical loading in compression and tension and was found to be in good agreement. The tower response was back-analysed as a simple push–pull model and the calculated uplift capacity of the footing backfill provided a close match to the observed response of the tower footings subjected to slow pushover. During fast pushover, the additional capacity mobilized due to tensile resistance (suction) created by the reverse bearing capacity beneath the base of the footings subjected to uplift was quantified using a suction capacity factor.

This record has no associated files available for download.

Contributors

Download statistics