The University of Southampton
University of Southampton Institutional Repository

Design of a fibre optic acoustic sensor array: sensitivity and noise properties

Design of a fibre optic acoustic sensor array: sensitivity and noise properties
Design of a fibre optic acoustic sensor array: sensitivity and noise properties
In this thesis the study of a multiplexed Fibre Optic Acoustic Sensor (FOAS) system is presented. Narrowband reflectors (Fibre Bragg Gratings or FBGs) define sensing sections of 12.5 metres, which then act as Fabry-Perot (FP) cavities. Low-coherence interferometry is used to interrogate the sensors with an accuracy of 50 µrad/√Hz, in good agreement with the theoretically predicted value. Heterodyne signal processing is used to eliminate low frequency environmental noise. The performance of the sensor is checked by a sinusoidal calibration signal generated by a PZT fibre stretcher. The sensor has a flat frequency response at 10 kHz with a high sensitivity of 50 µrad/√Hz and a dynamic range of 80 dB. The use of FBG based interferometers allows the use of Wavelength Division Multiplexing (WDM) technology allowing us to multiplex large number of sensors in the system.

The sensing system uses Amplified Spontaneous Emission (ASE) sources for illumination purposes. ASE sources are an attractive option for interrogating arrays of FBG sensors. The coherence features of broadband ASE light makes it attractive to be used in sensing applications, since Coherence Multiplexed (CM) systems interrogated with these sources do not suffer from phase induced intensity noise, which is a problem when employing laser sources.

It is well known that ASE sources suffer from excess photon noise, which is the dominant type of noise and hence limits the systems sensitivity. To get an idea of the impact of this type of noise on the performance of the system, the noise properties have been studied in detail both theoretically and experimentally. Noise spectra are calculated from the autocorrelation function of the output detector current for a thermal-like source.

It is well known that unbalanced interferometers (with delay time T) act as filtering elements and produce a noise spectrum with peaks at integer multiples of 1/T, due to filtered source intensity noise. The noise analysis is used to evaluate the performance of the sensor system, and to calculate the optimum reflectivity of both FBGs in the FP sensing cavity. Optimum reflectivities for both FBGs in the FP sensors have been found. Theoretical calculations show that the best phase resolution and visibility is obtained for R1 = 40 % and R2 = 100 %. This has been verified with experiments. We also established the robustness of the system to FBG drift.

A first demonstration of a FOS interrogation system using a low-coherence ASE source with a Semiconductor Optical Amplifier (SOA) is presented. The SOA is Gain-Saturated and thereby reduces the dominant intensity noise originating from the ASE source, improving the systems Signal to Noise Ratio (SNR).
Haaksman, R.P.H.
f559e273-cc06-469d-b667-31c260550dc7
Haaksman, R.P.H.
f559e273-cc06-469d-b667-31c260550dc7
Richardson, D.J.
ebfe1ff9-d0c2-4e52-b7ae-c1b13bccdef3

Haaksman, R.P.H. (2002) Design of a fibre optic acoustic sensor array: sensitivity and noise properties. University of Southampton, Department of Electronics and Computer Science, Doctoral Thesis.

Record type: Thesis (Doctoral)

Abstract

In this thesis the study of a multiplexed Fibre Optic Acoustic Sensor (FOAS) system is presented. Narrowband reflectors (Fibre Bragg Gratings or FBGs) define sensing sections of 12.5 metres, which then act as Fabry-Perot (FP) cavities. Low-coherence interferometry is used to interrogate the sensors with an accuracy of 50 µrad/√Hz, in good agreement with the theoretically predicted value. Heterodyne signal processing is used to eliminate low frequency environmental noise. The performance of the sensor is checked by a sinusoidal calibration signal generated by a PZT fibre stretcher. The sensor has a flat frequency response at 10 kHz with a high sensitivity of 50 µrad/√Hz and a dynamic range of 80 dB. The use of FBG based interferometers allows the use of Wavelength Division Multiplexing (WDM) technology allowing us to multiplex large number of sensors in the system.

The sensing system uses Amplified Spontaneous Emission (ASE) sources for illumination purposes. ASE sources are an attractive option for interrogating arrays of FBG sensors. The coherence features of broadband ASE light makes it attractive to be used in sensing applications, since Coherence Multiplexed (CM) systems interrogated with these sources do not suffer from phase induced intensity noise, which is a problem when employing laser sources.

It is well known that ASE sources suffer from excess photon noise, which is the dominant type of noise and hence limits the systems sensitivity. To get an idea of the impact of this type of noise on the performance of the system, the noise properties have been studied in detail both theoretically and experimentally. Noise spectra are calculated from the autocorrelation function of the output detector current for a thermal-like source.

It is well known that unbalanced interferometers (with delay time T) act as filtering elements and produce a noise spectrum with peaks at integer multiples of 1/T, due to filtered source intensity noise. The noise analysis is used to evaluate the performance of the sensor system, and to calculate the optimum reflectivity of both FBGs in the FP sensing cavity. Optimum reflectivities for both FBGs in the FP sensors have been found. Theoretical calculations show that the best phase resolution and visibility is obtained for R1 = 40 % and R2 = 100 %. This has been verified with experiments. We also established the robustness of the system to FBG drift.

A first demonstration of a FOS interrogation system using a low-coherence ASE source with a Semiconductor Optical Amplifier (SOA) is presented. The SOA is Gain-Saturated and thereby reduces the dominant intensity noise originating from the ASE source, improving the systems Signal to Noise Ratio (SNR).

Text
Haaksman_2002_thesis_2645.pdf - Author's Original
Restricted to Repository staff only
Available under License University of Southampton Thesis Licence.

More information

Published date: 2002
Organisations: University of Southampton, Optoelectronics Research Centre, Electronics & Computer Science

Identifiers

Local EPrints ID: 15486
URI: http://eprints.soton.ac.uk/id/eprint/15486
PURE UUID: f4b1ba28-adf1-4256-ab3c-8b6db4fdd611
ORCID for D.J. Richardson: ORCID iD orcid.org/0000-0002-7751-1058

Catalogue record

Date deposited: 24 May 2005
Last modified: 16 Mar 2024 02:40

Export record

Contributors

Author: R.P.H. Haaksman
Thesis advisor: D.J. Richardson ORCID iD

Download statistics

Downloads from ePrints over the past year. Other digital versions may also be available to download e.g. from the publisher's website.

View more statistics

Atom RSS 1.0 RSS 2.0

Contact ePrints Soton: eprints@soton.ac.uk

ePrints Soton supports OAI 2.0 with a base URL of http://eprints.soton.ac.uk/cgi/oai2

This repository has been built using EPrints software, developed at the University of Southampton, but available to everyone to use.

We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we will assume that you are happy to receive cookies on the University of Southampton website.

×