Aerofoil dipole noise due to flow separation and stall at a low Reynolds number
Aerofoil dipole noise due to flow separation and stall at a low Reynolds number
Aerofoil self-noise produced by flow separation and stall is relatively little understood regarding the underlying generation mechanisms. The focus of this work is to provide an improved level of understanding particularly with regard to the dipole noise sources utilising a high-fidelity direct numerical simulation. A NACA0012 aerofoil is considered under three different flow conditions at a Reynolds number Re∞=50,000 and a Mach number M∞=0.4. These include: a pre-stall condition with a laminar separation bubble (α=5°), near-stall (α=10°), and fully stalled (α=15°). The noise radiation in the far-field is significantly increased at low frequencies for the full-stall case for all observer directions which is consistent with previous experimental observations. The dominant source regions for each configuration are identified for low, medium and high frequencies, separately. A number of key findings are made concerning the source characteristics in full-stall which differ considerably from the lower angle of attack cases. It is found that the location of the dominant sources changes more significantly with frequency for the full-stall case. Additionally, for medium to high frequencies the maximum acoustic source amplitude is weaker for the full-stall case, despite comparable levels observed in the far-field. This seemingly contradictory observation highlights the importance of phase variations in the wall pressure fluctuations. For the frequencies considered in this paper it is shown that the full-stall case usually produces a relatively more in-phase source distribution, resulting in a more efficient radiation despite the lower amplitude levels. The important flow structures which are responsible for the dipole sources are also identified through analysis of the pressure field at isolated frequencies. It is found that for low frequencies coherent structures in the shear layer are responsible for the scattering of the wall pressure fluctuations at the TE, which agrees with previous findings in the literature. However, at medium and high frequencies the shear layer structures are found to be relatively weak in the proximity of the TE. This indicates that the noise may be generated through other means, for example scattering of fluctuating pressure induced by vortices shed from the TE.
Aeroacoustics, Aerofoil stall, Flow separation
Turner, Jacob
8618df92-3b0c-46e6-a482-dd12b261d9a7
Kim, Jae
fedabfc6-312c-40fd-b0c1-7b4a3ca80987
1 December 2020
Turner, Jacob
8618df92-3b0c-46e6-a482-dd12b261d9a7
Kim, Jae
fedabfc6-312c-40fd-b0c1-7b4a3ca80987
Turner, Jacob and Kim, Jae
(2020)
Aerofoil dipole noise due to flow separation and stall at a low Reynolds number.
International Journal of Heat and Fluid Flow, 86, [108715].
(doi:10.1016/j.ijheatfluidflow.2020.108715).
Abstract
Aerofoil self-noise produced by flow separation and stall is relatively little understood regarding the underlying generation mechanisms. The focus of this work is to provide an improved level of understanding particularly with regard to the dipole noise sources utilising a high-fidelity direct numerical simulation. A NACA0012 aerofoil is considered under three different flow conditions at a Reynolds number Re∞=50,000 and a Mach number M∞=0.4. These include: a pre-stall condition with a laminar separation bubble (α=5°), near-stall (α=10°), and fully stalled (α=15°). The noise radiation in the far-field is significantly increased at low frequencies for the full-stall case for all observer directions which is consistent with previous experimental observations. The dominant source regions for each configuration are identified for low, medium and high frequencies, separately. A number of key findings are made concerning the source characteristics in full-stall which differ considerably from the lower angle of attack cases. It is found that the location of the dominant sources changes more significantly with frequency for the full-stall case. Additionally, for medium to high frequencies the maximum acoustic source amplitude is weaker for the full-stall case, despite comparable levels observed in the far-field. This seemingly contradictory observation highlights the importance of phase variations in the wall pressure fluctuations. For the frequencies considered in this paper it is shown that the full-stall case usually produces a relatively more in-phase source distribution, resulting in a more efficient radiation despite the lower amplitude levels. The important flow structures which are responsible for the dipole sources are also identified through analysis of the pressure field at isolated frequencies. It is found that for low frequencies coherent structures in the shear layer are responsible for the scattering of the wall pressure fluctuations at the TE, which agrees with previous findings in the literature. However, at medium and high frequencies the shear layer structures are found to be relatively weak in the proximity of the TE. This indicates that the noise may be generated through other means, for example scattering of fluctuating pressure induced by vortices shed from the TE.
Text
Manuscript-Preprint
- Author's Original
More information
Accepted/In Press date: 20 September 2020
e-pub ahead of print date: 30 September 2020
Published date: 1 December 2020
Keywords:
Aeroacoustics, Aerofoil stall, Flow separation
Identifiers
Local EPrints ID: 444347
URI: http://eprints.soton.ac.uk/id/eprint/444347
ISSN: 0142-727X
PURE UUID: edec5aa7-7d27-4dc8-aa5c-0ac158eadee5
Catalogue record
Date deposited: 13 Oct 2020 16:51
Last modified: 17 Mar 2024 03:00
Export record
Altmetrics
Contributors
Author:
Jacob Turner
Download statistics
Downloads from ePrints over the past year. Other digital versions may also be available to download e.g. from the publisher's website.
View more statistics